KAM PLUS using AGWPE for BPQ

BPQ32 by G8BPQ (John Wiseman)
http://www.cantab.net/users/john.wiseman/Documents/index.html

KAM PLUS using AGWPE for BPQ

Postby k6irf on Sun Dec 14, 2014 5:07 pm

Sometimes my KAM PLUS will not work with AGWPE after working for a few months without any hitch.
Here are the commands I use to get it working again.

1. Use a terminal program to connect directly to the Kam Plus. In my case I use Paclink's Simple Terminal. You can access this under Help.
2. Once you get the CMD prompt. Use the restore command to put it back to factory defaults.
CMD: RESTORE DEFAULTS
3. Type asterisk ****** to get over the auto baud routine.
4. Once you're back in the CMD prompt, use command CMD:INTFACE TERM
This will put your TNC in terminal mode.
5. Run AGWPE and you will see that the TNC is now responding to the AGWPE command. The Led will move.
The STA led will blink a few times and this indicates being setup in Kiss mode.
User avatar
k6irf
Site Admin
 
Posts: 155
Joined: Sat Aug 13, 2005 5:16 pm
Location: Claremont, California

Return to BPQ32

Who is online

Users browsing this forum: No registered users and 1 guest

cron